The Lead2exam 300-135 dumps PDF is set up as a series of trouble tickets in the topology mentioned above. There is a problem description and you have access to the consoles of simulated equipment to try and determine the cause. After you have investigated, you answer three questions to narrow down the cause and the solution, then you move on to the next ticket.

Vendor: Cisco
Certifications: CCNP Routing and Switching
Exam Name: Troubleshooting and Maintaining Cisco IP Networks (TSHOOT v2.0)
Exam Code: 300-135
Total Questions: 82 Q&As

If you know your stuff, it’s a pretty easy exam. That said, don’t get too comfortable. I started running out of time because I was taking too relaxed of an approach and ended up using almost the entire time to complete the Lead2exam 300-135 dumps. If you’ve taken the previous version:

  • The topology is the same (as best I can tell)
  • The question style for the tickets is the same.
  • You are no longer allowed to abort a ticket. You must finish once started and you must answer in the order delivered.
  • The simple multiple choice questions are spread throughout the test instead of all being at the beginning.
  • The interface is different. There are no tabs for the Lead2exam 300-135. You just click “next” when you are finished with your answers.

300-135

Lead2exam Latest and Most Accurate Cisco 300-135 Dumps Exam Q&As

QUESTION 3
A customer network engineer has made configuration changes that have resulted in some loss of connectivity. You have been called in to evaluate a switch
network and suggest resolutions to the problems.

300-135

300-135

300-135

300-135

You have configured PVST+ load balancing between SW1 and the New_Switch in such a way that both the links E2/2 and E2/3 are utilized for traffic flow, which
component of the configuration is preventing PVST+ load balancing between SW1 and SW2 links
A. Port priority configuration on SW1
B. Port priority configuration on the New_Switch
C. Path cost configuration on SW1
D. Path cost configuration on the New_Switch
Correct Answer: D
Explanation
Explanation/Reference:
Explanation:
Here is the configuration found on the New_Switch:

300-135

This causes the port cost for link eth 1/3 to increase the path cost to 250 for all VLANs, making that link less preferred so that only eth 1/2 will be used.

 

 

QUESTION 4
A customer network engineer has made configuration changes that have resulted in some loss of connectivity. You have been called in to evaluate a switch
network and suggest resolutions to the problems.

300-135

300-135

300-135

300-135

Refer to the topology.
SW1 Switch Management IP address is not pingable from SW4. What could be the issue?
A. Management VLAN not allowed in the trunk links between SW1 and SW4
B. Management VLAN not allowed in the trunk links between SW1 and SW2
C. Management VLAN not allowed in the trunk link between SW2 and SW4
D. Management VLAN ip address on SW4 is configured in wrong subnet
E. Management VLAN interface is shutdown on SW4
Correct Answer: D
Explanation
Explanation/Reference:
Explanation:
In the network, VLAN 300 is called the Management VLAN. Based on the configurations shown below, SW1 has VLAN 300 configured with the IP address of
192.168.10.1/24, while on SW4 VLAN 300 has an IP address of 192.168.100.4/24, which is not in the same subnet.

300-135

300-135

 

Question Set 2
QUESTION 1
You have been brought in to troubleshoot an EIGRP network. A network engineer has made configuration changes to the network rendering some locations
unreachable. You are to locate the problem and suggest solution to resolve the issue.

300-135

300-135

300-135

300-135

300-135

R5 has become partially isolated from the remainder of the network. R5 can reach devices on directly connected networks but nothing else. What is causing the
problem?
A. An outbound distribute list in R3
B. Inbound distribute lists in R5
C. An outbound distribute list in R6
D. Incorrect EIGRP routing process ID in R5
Correct Answer: B
Explanation
Explanation/Reference:
Explanation:
Here we see that distribute list 3 has been applied to EIGRP on router R%, but access-list 3 contains only deny statements so this will effectively block all routing
advertisements from its two EIGRP neighbors, thus isolating R5 from the rest of the EIGRP network:

300-135

300-135

We are offering learning material for 300-135 Troubleshooting and Maintaining Cisco IP Networks (TSHOOT) exam by considering the real Cisco 300-135 exam criteria.  Our highly educated experts are devoting their duties to prepare most relevant Lead2exam 300-135 dumps questions for you. Try our free demo version which indicates real CCNP Routing and Switching/CCNP300-135 exam scenario including exam time, types of questions and other necessary details.

Our experts have made two types of learning material according to the need of 300-135 Troubleshooting and Maintaining Cisco IP Networks (TSHOOT) exam applicants. We are providing PDF format solved questions and answers and Lead2exam 300-135 dumps Troubleshooting and Maintaining Cisco IP Networks (TSHOOT) exam.